Q & A: Glue-Line Rip Blade

Q & A: Glue-Line Rip Blade glue-line blade


I use my jointer to clean up sawn edges before glue-up. The results are great except when I try to joint figured wood. Any suggestions?


Jointing highly figured wood often leaves nasty tear-out. It’s times like these that a tablesaw and a specialized blade called a glue-line rip blade come in handy. A glue-line rip blade produces a much smoother edge than even the best 40-tooth combination blade can.

Glue-line rip blades are designed and used differently than standard rip blades. General-purpose rip blades are made for fast, rough cuts. Typically, they have 24 flatground teeth. A typical glue-line rip blade, on the other hand, has 30 teeth with every other tooth having a “triple-chip grind.” The triple-chip tooth hogs out most of the material and the flat tooth cleans up what’s left. This produces an ultra-smooth cut that’s ready for glue-up.

You set up a glue-line rip blade differently than you do a typical blade (see photo, left). You’ll get the best results by feeding the stock at a slow, steady rate.

Q & A: Glue-Line Rip Blade glue-line blade

The glue-line rip blade should be set so no more than one-quarter of the height the tooth is above the wood.

This story originally appeared in American Woodworker July 2006, issue #122.

Q & A: Glue-Line Rip Blade glue-line blade

July 2006, issue #122

Purchase this back issue.

Q & A: Glue-Line Rip Blade glue-line blade